Company profile

Company philosophy

Conrad Roland


The Seilakademie

Planning aids

Technical information






As Corocord is a part of the KOMPAN Group, all Corocord products are covered by the general KOMPAN warranty.

•    Galvanised structural parts
    -    Steel poles
    -    Cross beams
    -    Floor frames
    -    Top brackets
•    Stainless steel hardware
•    EcoCoreTM and other HDPE panels

•    Engineered robinia timber

•    HPL floors & panels
•    Galvanised and aluminium metal parts with painted top layer
•    Other galvanised metal parts
•    Other stainless steel parts
•    “S” clamps of stainless steel
•    Solid plastic parts
•    Non-painted metal parts
•    Other engineered timber

•    Resin coated plywood plates
•    Hollow plastic parts
•    Other painted metal parts
•    Springs & ball bearing assemblies
•    Rope & net constructions
•    Concrete elements
•    Flexotop virgin EPDM

•    Moveable plastic & metal parts
•    EPDM rubber membranes material
•    Electronic components
•    Flexotop recycled EPDM

* KOMPAN’s LIFETIME warranty is in effect for the lifetime of the product until the product is uninstalled and/or taken out of use. In addition, KOMPAN’s general terms & delivery conditions apply and supplement this warranty.

1. Warranty coverage
This warranty applies to KOMPAN’s products for the time periods described for each product type above and with the limitations described in this warranty. The warranty period applies from the date of purchase by the first customer. This warranty covers only defects in materials. KOMPAN’s liability under this warranty is limited to repair or replacement of defective products, without charge, at KOMPAN’s discretion. Defective electronic components will be delivered and changed by a KOMPAN ICON Professional installer free of charge.

2. Warranty applies only if products have been properly installed and maintained
The warranty only applies if KOMPAN’s products have been installed according to the instructions provided by KOMPAN, and maintained correctly according to the KOMPAN Maintenance Manual. The warranty for the ICON electrical components is dependent on those products being installed by an ICON trained and approved installer.

3. No coverage for accidents, wear, tear, cosmetic issues, misuse or vandalism
This warranty does not cover any damage caused by accident, improper care, negligence, normal wear and tear, surface corrosion on metal parts, discoloured surfaces and other cosmetic issues or failures due to misuse or vandalism. Natural changes in wood over time are considered cosmetic issues and not covered.

4. Products installed near water
Products installed in direct contact with chlorinated water or saltwater (Waterparks), or products installed with occasional contact with such water or installed so close to the shore they are subjected to salt spray are not covered by the KOMPAN warranty for any defects caused by corrosion. Products installed in coastal areas, within 200 metres from the shore, will only be covered by the warranty for half the period of the standard product warranty in relation to defects caused by corrosion. KOMPAN’s Lifetime warranty if applicable is limited to a 5 year warranty in relation to such products.

5. Third party supplied products & services

KOMPAN provides non-KOMPAN branded products and installation services performed by certified third party suppliers. This general KOMPAN warranty does not apply to such non-KOMPAN branded products and installation services, which may carry their own warranties. KOMPAN will pass on information on such warranties where possible.